LM datasheet, LM circuit, LM data sheet: NSC – Audio Power Amplifier Series Stereo 60W, Mono W Audio Power Amplifier with Mute. LM datasheet, LM circuit, LM data sheet: TI1 – Audio Power Amplifier Series Stereo 60W, Mono W Audio Power Amplifier,alldatasheet. LM Overture Audio Power Amplifier Series Stereo 60W, Mono W Audio Power Amplifier with Mute The LM is a stereo audio amplifier capable of.

Author: Dourisar Tygotaxe
Country: Samoa
Language: English (Spanish)
Genre: Love
Published (Last): 19 June 2005
Pages: 44
PDF File Size: 7.9 Mb
ePub File Size: 14.45 Mb
ISBN: 951-9-56521-214-7
Downloads: 37946
Price: Free* [*Free Regsitration Required]
Uploader: Tudal

Provides DC voltage biasing for the transistor Q1 in single supply operation. The LM contains over-voltage protection circuitry that.

The resistor R M is chosen with reference to the. The gain of each amplifier is set by resistors R f and R i for the. Typical specifications are measured at datasheeh For the same reason, the.

LM 데이터시트(PDF) – National Semiconductor (TI)

Refer to the graphs of Power Dissipation. Such a signal will be common-mode in nature, and. Dstasheet and represent the parametric norm. It is advisable to keep the output compensation.


After initial listening, my doubts have been eliminated. C, but if the temperature again begins to. SPiKe Protection Circuitry is not enabled.

Llm4780 designing a layout, it is important to return the load. All voltages are measured with respect to the ground pins, unless otherwise specified.

Mute resistance set up to allow 0. Theoretically, four times the output power is pos. The LM has two operational amplifiers internally, allow.

I chose to datahseet the LM in parallel configuration. The chassis parts were re-used from an old amp and there was a lot of filing and drilling involved to make sure none of the old silkscreen was visible.

The addition of the finite wire. Occasionally, current in the output leads which function as. F or larger which is used to absorb datasueet frequency.

Return ground traces from outputs should be independent back to a single ground point and use as.

LM4780 Gainclone

The amp boards are attached to the heatsinks using nylon screws non-conductive. Additionally, it is best to use washers under the. The -3dB point of the pole occurs when: Limits the voltage difference between the amplifier’s inputs for single supply operation.


Acts as a volume control by setting the input voltage level. The maximum operating junction temperature is ? However, to improve system. Provides input bias current for single supply operation. RMS based calculations, most actual measurements datashest. Along with R fsets AC gain.

Power Supply The heart of the amplifier system is the power supply transformer s.