EEPROM 95160 PDF

EEPROM 95160 PDF

STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Dilrajas Juran
Country: Namibia
Language: English (Spanish)
Genre: Technology
Published (Last): 5 March 2007
Pages: 17
PDF File Size: 6.77 Mb
ePub File Size: 16.77 Mb
ISBN: 251-3-36044-660-8
Downloads: 45609
Price: Free* [*Free Regsitration Required]
Uploader: Mausar

Reply 10 benaknoun Spain Posts. What is your another adapter part number? Which part number you selected in software? Device blank check failed at address: Use ToolA instead, because your chip pins already damaged.

You can save data as. Reply 3 ZLM Posts. Reply 5 ZLM Posts. The wire can be any wires, as long as you can solder it. Reply 15 ZLM Posts. Reply 9 ZLM Posts. Try to power up the board and do not connect pin 8 Vcc pin.

  ARALDITE 2022 PDF

All other pins are pin to pin connect to programmer socket. That is safe and fastest way.

Reply 2 benaknoun Spain Posts. You need to find a way to test the data. Reply 4 benaknoun Spain Posts.

Also, another question please about the same chip: Chip is blank does this mean this chip is empty??? If the chip is not designed for programming in circuit, then you need to try to find some connection.

What is your chip on board? Reply 11 benaknoun Spain Posts. It is SOIC8 mil chip.

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

Reply 8 benaknoun Spain Posts. Once the chip is blank, then you can load your data file and click on Write button to wrtie the data eeprmo chip. I think it should be SOIC8 mil chip. Hi, i have connected the tool to the chip and adapter to the programmer.

The only way to test data is: Reply 12 ZLM Posts. Also, when i click on ID, it says “function not supported on this device” Image Insert: Reply 13 benaknoun Spain Posts.

  DP32746 MANUAL PDF

Hi, it seems i’m doing something right then! It should be able to open it by same software. Reply 18 benaknoun Spain Posts. Most of used on-board chips should have something.

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Reply 7 ZLM Posts. But the fast way is to remove it from board and program it on the programmer ZIF spcket directly. What is exact part number? That is depending on your circuit design. When you uploading the image, only use letter and number as file name.

Reply 6 benaknoun Spain Posts.