Descriptor and Table of Contents (1 of 24) for 3GPP TS – Mobile radio interface Layer 3 specification – Core network protocols; Stage 3. 3GPP TS End to end quality of service concept and architecture. 3GPP TS Architecture Principles for Relase 3GPP TS Mobile radio . 3GPP TS specifies that a UE should delete its stored TMSI and LAI after a the RRC connection establishment cause is definedwithin 3GPP TS
|Published (Last):||24 February 2011|
|PDF File Size:||2.86 Mb|
|ePub File Size:||2.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
The amount by which a core specification performance requirement is relaxed to take into account factors such as measurement uncertainty. The cyclic shift indices of the M- sequences are derived from a function of the physical layer cell identity group. A network-based mobility management mechanism. The extension was designed to increase the channel model bandwidth from 5MHz to MHz, while remaining simple and backward-compatible with the original SCM.
The value of this ts4.008, and the period for which the RNTP indicator is valid in the future, are configurable. Multimedia Broadcast and Multicast Service. Implementation eXtra Information for Testing.
Online 2G/GSM, 3G/UMTS, 4G/LTE Message Analyser
A form of distortion of a signal in which one symbol interferes with subsequent symbols. An access scheme allowing multiple users ts24.080 share the same frequency channel by dividing the channel into different time slots. In the time domain this is equivalent to introducing a delay which is cyclic because it is applied before insertion of the Cyclic Prefix CP. This is achieved by applying a timing advance at the UE transmitter, relative to the received downlink timing.
A measure 3gp the width of a range of frequencies, measured in Hertz. It is arises from the fact that the RESENS requirements are more challenging in some bands and duplex spacings than others. Voice over Internet Protocol. In PS communication each data packet is labelled with the destination address and routed over a shared transmission resource.
Internet Protocol Connectivity Access Network. The MCS therefore describes the information data rate of a transmission.
Home Public Land Mobile Network. First Missing Service Data Unit. Secondary Multicast Control CHannel. In LTE, turbo codes were instead selected as the channel coding technique. The BI may be used for example in network overload situations.
3GPP Message Analyser – 2G, GSM, 3G, UMTS, 4G, LTE message decoding and encoding
These sessions include two-way voice or video call, collaborative multi-media ts2.008 session, streaming multimedia distribution, instant messaging and online games. The performance requirements specify minimum throughput which is to be met under this condition. It is a scalar which refers to access node- specific parameters that control bearer-level packet forwarding treatment e.
A test model used for LTE conformance testing. 3g;p user is allocated a different time slot. Adjacent Channel Leakage Ratio. Ciphering Key Sequence Number. Inverse Discrete Fourier Transform. Non-GBR bearers do not guarantee any particular bit rate, and are typically used for applications as web-browsing. It is sometimes used as an indication of the extent of the linear region of operation that is required for the Power Amplifier PA ; however, the Cubic Metric CM of the signal is a more reliable predictor of the required PA characteristics.
The OI can take three values, expressing low, medium, and high levels. Typically refers to equipment 3gppp conformance testing.
A set of parameters used to describe a configuration for packet-based performance evaluation of 3GPP systems in which the adaptation of modulation and coding rate is in principle possible e. A group of four Resource Elements REs. Thus in each symbol period, all the transmitted subcarriers of an SC-FDMA signal carry a component of each modulated data symbol.
The RNL encompasses the radio network control plane and the radio network user plane.
SI consists of cell- and network-specific parameters which are broadcast to allow UEs to connect successfully to the network. The PCO may include the address allocation preference indicating that the UE prefers to obtain an IPv4 address only after the default bearer activation. It is generally added to a received signal to simulate the effect of thermal noise and other sources of noise or interference. LB may result in hand-over or cell reselection decisions. The selected subset changes periodically such that a block of data is transmitted from different antennas at different times.
Linear Minimum Mean Squared Error. Visited Public Land Mobile Network. Used in the context of repeaters. A parameter of the RObust Header Compression ROHC protocol, representing the size of the largest reconstructed unit in octets that the decompressor is expected to reassemble from segments.
The UE-manufacturer-declared supply voltage level from a battery or mains below which a UE has to fulfil all the LTE specification requirements. A set of conditions and procedures under which a tester will deter- mine whether certain specification requirements are met.
The MSE is the second order moment of the difference between the estimate and the true value of the quantity being estimated. A timer whose duration is configured by the eNodeB, which is restarted each time a timing advance command is received. An oscillator whose frequency is determined by the level of a control voltage input.